MAXTOR CORPORATION

AT ADAPTER BOARD

Data bus: 16-bit, ISA

Size: Half-length, full height card

Hard drives supported: Two IDE (AT) Interface drives

Floppy drives supported: None

[Image]

                             CONNECTIONS

                    Function                          Location

  40-pin AT Interface (IDE) connector-internal           CN1

  2-pin connector-drive active LED                       CN2

                        USER CONFIGURABLE SETTINGS

              Function                    Location            Setting

  »   Hard drive port address is        JP1/Jumper 1           open
      1F0-1F7h

      Hard drive port address is        JP1/Jumper 1          closed
      170-177h

  »   I/O Channel Ready enabled         JP1/Jumper 2          closed

      I/O Channel Ready disabled        JP1/Jumper 2           open

  »   Factory configured - do not       JP1/Jumper 3           open
      alter

  »   Factory configured - do not       JP1/Jumper 4          closed
      alter

  »   Factory configured - do not       JP1/Jumper 5           open
      alter

  »   Drive active LED enabled          JP1/Jumper 6          closed

      Drive active LED disabled         JP1/Jumper 6           open